How do I change the frequency on my iClicker remote?

Document created by Digital Support on May 19, 2017
Version 1Show Document
  • View in full screen mode
If your instructor has selected a frequency other than the default (AA), iClicker will display an alert when your instructor starts polling. Directions for changing the frequency are also on the back of every remote.

Important: In order to change your frequency, your instructor must first start a polling session. You cannot change your frequency unless their is an active polling session. 

Original iClicker remote:
  1. Press and hold the power button on the remote until the “Vote Status” light begins flashing.
  2. Use the A-E buttons to enter the two-letter frequency code. The A-E LEDs flash green indicating the frequency change was successful.
iClicker +: 
  1. Press and hold the Power button until the Power light flashes green
  2. Use the A-E buttons to enter the two-letter frequency code. The A-E LEDs flash green indicating the frequency change was successful.
iClicker 2:
  1. Press and hold the Power button until the two-letter frequency on the LCD flashes.
  2. Use the A-E buttons to enter the new two-letter frequency code. A checkmark appears on the LCD indicating the frequency change was successful.
Both iClicker + and iClicker 2 remotes remember the last saved frequency.

Attachments

    Outcomes