iOLab > Getting Started

Document created by Digital Support on Feb 20, 2018Last modified by Digital Support on Mar 13, 2018
Version 3Show Document
  • View in full screen mode


Getting started with your iOLab is easy! Below is a brief overview of each step. Click the article links for more detailed information on that step.


Preparing your iOLab

If your device is not brand new you can skip this step. If you just bought your device, this article and video will help you figure out what's in the box and what to do with the red felt pads in the accessory kit: Preparing Your iOLab.


Install software


Run iOLab for the first time

Plug your device's dongle into the USB port and open the iOLab application. Turn on your iOLab remote using the power button. Make sure your remote is successfully paired with the dongle. Calibrate your iOLab remote.

Record data

Record data by selecting one or more sensors from the checklist at the left of the the iOLab application, then clicking the Record button at the top. Click Stop in the same place as Record to stop recording.

View data

Once you have some data recorded, you can review and manipulate it by following the instructions here: Viewing Data

Share data

You can also share recorded data online by following the instructions here: Sharing Data